Mercury+ ST1

Mercury+ ST1 is a carrier board from Enclustra.

• MPN: ME-ST1-W
• Type: carrier board
• Vendor: Enclustra
• Status: active
• Price: 375 USD
• Product page: https://www.enclustra.com/en/products/base-boards/mercury-st1/
• Catalog page: https://boards.fpgadeveloper.com/carriers/ME-ST1-W
• Structured data (JSON): https://boards.fpgadeveloper.com/data/carriers.json

Specifications

• Clocking:
• Programmable: Yes
• Networking:
• SFP Plus: 1
• Ethernet:
• Speed: 1000; Ports: 2; Endpoint: rj45
• Video:
• HDMI Out: 1
• Displayport: 1
• Mipi Csi: 2
• Mipi Dsi: 1
• USB:
• Connector: Type-A; Speed: 3.0; Role: host
• Connector: Type-B; Speed: 3.0; Role: device
• USB Bridge:
• Connector: Micro-B
• Functions:
• jtag
• uart
• Expansion:
• FMC:
• Slot: HPC0; Type: hpc; Vadj Min: 1.2; Vadj Max: 3.3
• Storage:
• Microsd: 1

Compatibility

Used in kits

• Mercury XU5 Design-in Kit (QSK-DK-ME-XU5-4EV-ST1)

Notes

FMC VADJ (VCC_FMC_ADJ) is fed from the VCC_IO_B rail, selected by the I/O voltage selection jumpers on J1602: 1.2 V (VCC_1V2), 3.3 V (VCC_3V3), or the module-dependent VCC_OUT_A / VCC_OUT_B supplies (supported envelope 1.2-3.3 V). Enclustra's documents conflict on the factory default: the user manual (D-0000-456-001 V03) states that no I/O voltage is applied as shipped, yet the default jumper positions listed in both the manual and the schematic (R1.0) include 7-8, which sets VCC_IO_B — and hence VADJ — to 3.3 V; verify J1602 before powering an FMC card. The board does not read the FMC IPMI EEPROM.

--- *Machine-readable catalog entry from https://boards.fpgadeveloper.com. Full dataset: https://boards.fpgadeveloper.com/llms.txt*