Mercury+ PE1

Mercury+ PE1 is a carrier board from Enclustra.

• MPN: ME-PE1-C
• Type: carrier board
• Vendor: Enclustra
• Status: active
• Product page: https://www.enclustra.com/en/products/base-boards/mercury-pe1-300-400/
• Catalog page: https://boards.fpgadeveloper.com/carriers/ME-PE1-C
• Structured data (JSON): https://boards.fpgadeveloper.com/data/carriers.json

Specifications

• PCIe:
• Type: Edge; Gen: 2; Lanes: 4
• Networking:
• Ethernet:
• Speed: 1000; Ports: 2; Endpoint: rj45
• USB:
• Connector: Type-A; Speed: 2.0; Role: host; Ports: 4
• Connector: Micro-B; Speed: 3.0; Role: device
• USB Bridge:
• Connector: Micro-B
• Functions:
• jtag
• uart
• Storage:
• Microsd: 1
• Expansion:
• Pmod: 3

Notes

ME-PE1-C is the generic Mercury+ PE1 base-board article; the populated options — FMC LPC vs HPC count, clock generator, system monitor, mPCIe/mSATA holder, SMA/MGT and SIM-card options — depend on the selected board model (PE1-200 / PE1-300 / PE1-400). See the model-specific articles (ME-PE1-200-C, ME-PE1-300-W, ME-PE1-400-W) for the per-model feature set.

The available features also depend on the equipped Mercury FPGA/SoC module.

The FMC connector I/O pins connect directly to the FPGA/SoC on the Mercury module and run at the module I/O voltage: VCC_IO_A / VCC_IO_B are selected with jumper J1800 among 3.3 V (VCC_3V3) or the module-dependent VCC_OUT_A / VCC_OUT_B supply outputs. The factory default jumper positions (1-3, 9-11) apply no I/O voltage at all, so the I/O rails are unpowered until the jumpers are set; the board does not read the FMC IPMI EEPROM. See the model-specific articles for per-slot VADJ ranges.

--- *Machine-readable catalog entry from https://boards.fpgadeveloper.com. Full dataset: https://boards.fpgadeveloper.com/llms.txt*