Mercury+ PE1-300

Mercury+ PE1-300 is a carrier board from Enclustra.

• MPN: ME-PE1-300-W
• Type: carrier board
• Vendor: Enclustra
• Status: active
• Price: 642 USD
• Product page: https://www.enclustra.com/en/products/base-boards/mercury-pe1-300-400/
• Catalog page: https://boards.fpgadeveloper.com/carriers/ME-PE1-300-W
• Structured data (JSON): https://boards.fpgadeveloper.com/data/carriers.json

Specifications

• PCIe:
• Type: Edge; Gen: 2; Lanes: 4
• Type: MiniPCIe-Full; Msata Capable: Yes
• Clocking:
• Programmable: Yes
• Sma Clock In: 1
• Sma Clock Out: 1
• Networking:
• Ethernet:
• Speed: 1000; Ports: 2; Endpoint: rj45
• USB:
• Connector: Type-A; Speed: 2.0; Role: host; Ports: 4
• Connector: Micro-B; Speed: 3.0; Role: device
• USB Bridge:
• Connector: Micro-B
• Functions:
• jtag
• uart
• Storage:
• Microsd: 1
• Expansion:
• Pmod: 3
• FMC:
• Slot: FMC1; Type: hpc; Vadj Min: 1.8; Vadj Max: 3.3

Notes

The available features depend on the equipped Mercury FPGA/SoC module and the selected PE1 board model. The -300 variant fits a low-jitter clock generator, system monitor, power control and current sense. The SMA clock / MGT and SIM-card options are populated to order.

FMC VADJ (VCC_ADJ) follows the module I/O voltage VCC_IO_B, selected by the I/O voltage selection jumpers on J2000: 3.3 V (VCC_3V3) or the module-dependent VCC_OUT_A / VCC_OUT_B supply outputs (typically 1.8-2.5 V; supported envelope 1.8-3.3 V depending on the mounted Mercury module). The factory default jumper positions (2-4, 8-10) apply no I/O voltage at all, so the VADJ rail is unpowered until the jumpers are set; the board does not read the FMC IPMI EEPROM.

--- *Machine-readable catalog entry from https://boards.fpgadeveloper.com. Full dataset: https://boards.fpgadeveloper.com/llms.txt*